Overview
- Standard Base for MQR III & MQR IV, for Witty I & for V-Bracket #2457010 from Baader Planetarium
- There is one central hole on it for a sink-head screw with hole diameter 6.30mm
- The other two alongated holes will allow securing it with two screws to a telescope.
- The two screws can be at distances between 25mm to 45mm, center-to-center, approximately.
- The uncertainty of measurement comes from the fact that the bottom of the base is curved.
- The 25mm to 45mm are center to center of two imaginary screws, as the actual distances are 21mm to 50mm.
Features: Baader Standard Finder Base For Witty I and V-Bracket
- Compact, lightweight, reliable and quickly interchangeable
- Suitable for mounting Baaders well known MQR III finder, MQR IV finder, Witty One fine tune assembly and Skysurfer finder
- Very safely hold most standard fitting finder/red dot scopes and can be attached to almost any telescopes including Schmidt-cassegrains
- Features 2 elongated holes that permit Spacing between the screws ranging from 27-45mm
Note: Please be sure to measure your hole spacing to ensure this will fit, prior to purchase
Specification: Baader Standard Finder Base For Witty I and V-Bracket
- Model : Standard Finder Base
- Designed For: MQR III finder, MQR IV finder, Witty One fine tune assembly and Skysurfer Finder Scopes
Kit Content
Baader Standard Finder Base For Witty I and V-Bracket
User Operating Instructions Manual
For more information about, Baader Standard Finder Base For Witty One and V-Bracket website.
Back to top
