Pulsar Thermal Zeroing Targets

Description: Pulsar Thermal Zeroing Targets

• Pulsar Thermal Zeroing Targets are the perfect solution for simple and precise zeroing of thermal imaging riflescopes.
• Pack contains 10 30x30cm paper targets and 10 40mm carbon activated adhesive heating pads.
• The adhesive heating pads will remain hot for 10-20 minutes on cold surfaces depending on weather conditions.

Ingredients: iron powder, activated carbon, vermiculite, salt, resin, water

To use these heated targets, follow the steps below:

• The heat pack is air-activated, do not open the pad packaging until you are ready to use it
• Open the packaging and take out the heat pad.
• Do not cut or damage the heat pad while taking it out
• Remove the paper strip from the back side of the heat pad to expose the adhesive surface
• Stick the heat pad with the adhesive side to the center of the paper target marked with circle
• There is no need to shake the heat pad, it will warm itself up in 3-5 minutes
• Attach the paper target to the desired location
• Aim at the heated pad with a thermal imaging scope mounted on the firearm and optimize thermal view, so that thermal pad is clearly visible.
• Perform zeroing procedure as described in the user manual of your thermal imaging device
• With the help of the round shape and small diameter of the pad, deviations of point of impact can be eliminated in just a few shots.

Kit Copntent:
Pulsar Thermal Zeroing Targets